REC-003374

active

0 Mazda Mazda6 L5

Category: Light Vehicle · Supplier: Mazda Australia Pty Limited

Recall date: 9 August 2011

Defect

It is possible that one of the circlips that retain the piston pins within the pistons has been incorrectly installed.

Hazard

If the clips fail during use, this may result in the piston pin sliding out of position and contacting the cylinder wall. The resultant damage could cause the engine to stall (if this should occur, the engine will not restart). In a worst case scenario, engine parts (conrods) may crack the oil pan on the bottom of the engine or the cylinder block, causing oil to leak.

Remedy

Owners of affected vehicles will be contacted by mail. Owners are advised to contact an authorised Mazda Dealer for replacement of the piston and connecting rod assemblies with revised ones.

What should you do?

Check your VIN below to confirm whether your specific vehicle is affected.
Contact the supplier — Mazda Australia Pty Limited — or your nearest authorised dealer to arrange the recall remedy.
Recall repairs are free of charge. The manufacturer or supplier is legally required to fix the defect at no cost to you.
If you have difficulty getting the recall addressed, contact the Department of Infrastructure or your state's consumer protection agency.

Check Your VIN

Enter your Vehicle Identification Number to check if your specific vehicle is affected by this recall.

Source: https://www.vehiclerecalls.gov.au/recalls/rec-003374